Whirlpool W10323246 Instructions D'installation page 9

7. When reattaching the upper front bracket, make sure the
central control bracket front is above the upper front bracket,
see Figure 12B. Insert and push down two (2) ear tabs on
either side of bracket, Figure 38. Reattach five (5) screws
as shown in Figures 12A and 12B.
(1 OF 2) TaBS
CORRECT FINaL
POSITION
8. When reattaching the blower housing lint duct and its screws,
see Figure 11, verify the lower plastic lint duct clip is hooking
the lint duct correctly. See Figure 39.
LINT DuCT
LINT DuCT
CLIP
3/8" LONg
SCREW
9. Reconnect the moisture sensor connector. See Figure 10.
10. Reinsert the lint screen. See Figure 9.
W10609999 A
© Whirlpool Corporation 2013
(All Rights Reserved)
WRONg FINaL
POSITION
figure 38
figure 39
11. When re-hanging the front panel and door assembly onto
the two (2) tabs, Figure 8, verify the door switch connector
is also properly fed up and behind the upper front bracket.
Attach the three (3) upper screws, Figure 7. Connect the
door switch, Figure 4. Holding the front panel in position to
prevent bending it, open the dryer door and reattach two
(2) Phillip-head screws, Figure 5. Attach the four (4) lower
screws, Figure 6.
12. Take the front console and feed the two connectors through
the right hole in the upper front bracket. Set the two console
bottom corner posts into the front panel top slots and tip the
console toward back clicking its top lip over the top edge of
the upper front bracket. Reconnect the drum light and main
console connectors, Figure 4. Reattach the two (2) upper
screws, Figure 3.
13. Take the front edge of the top panel and set it into the plastic
tray of the upper front bracket, Figure 2. Set the remaining
top panel down and slide it forward into position. Reattach
the two (2) rear screws, Figure 1.
14. Reposition dryer to operating position.
15. Connect external exhaust vent to dryer.
electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
16. Plug in dryer or reconnect power.
NOTE: For gas dryer application, connect flexible gas supply line
to rear of dryer. Turn on gas supply and check for leaks by brush-
ing or spraying approved non-corrosive leak detection solution
onto connection at rear of dryer. If any bubbles are present turn
off gas supply, tighten the leaking connection and retest for leaks.
17. Check to assure all components are attached securely in
place and lint screen has been installed to dryer.
18. Check that dryer is working properly.
— 9 —
WARNING