Whirlpool W10323246 Instructions D'installation page 3

14. Remove console mounting bracket by removing two (2)
screws securing bracket to cabinet left side panels, two (2)
screws from right side panel and one (1) screw from central
control bracket. Slightly lift assembly and remove from dryer.
See Figure 12A and 12B.
(2) SCREWS
-LEFT SIDE
CENTRaL
CONTROL
BRaCKET
W10609999 A
figure 12A
(3) SCREWS -
RigHt SiDe
uPPER FRONT BRaCKET
figure 12B
15. Remove bulkhead assembly by first removing four (4) screws
securing the bulkhead assembly to cabinet. Slightly lift up on
bulkhead assembly and at the same time pulling away from
drum working rollers off drum. See Figure 13.
NOTE: During removal of bulkhead, take special notice of the
lower protective shield to assure proper placement during reas-
sembly.
16. Swing bulkhead assembly to side and remove two (2) har-
ness clips by pinching ends with pliers to disconnect harness
from bulkhead. See Figure 14.
NOTE: This kit is used on some models that do not have the
harness routed in the front and do not have the harness clips.
(2) CLIPS - MaIN
HaRNeSS
— 3 —
(4) SCREWS
LOWER
PROTECTIVE
SHielD
figure 13
BulkHeaD
figure 14
(continued)