How To Operate - NOSTALGIA PRODUCTS WK17AQ Manuel D'instruction

HOW TO OPERATE

Before using for the first, it is recommended that you clean your WATER KETTLE. Simply
boil a full kettle of water and then discard the water. Repeat process once more.
1. First, find a flat surface near an electrical outlet before starting.
Make sure your cord is away from any water source.
2. To fill kettle with water, remove kettle from the Base, remove Lid, and fill with desired
amount of water.
CAUTION: If water exceeds the MAX line (1.7 liters) of water, the
boiling water may spill out during the boiling process.
3. Replace the Lid and position the kettle back on the Base. Make
sure the kettle is completely in contact with the Base.
4. Plug the power cord into an electrical outlet, then press the Switch to the ON position to
begin boiling water. The indicator light will illuminate red.
NOTE: The kettle will switch off automatically once the water has boiled. You can shut off
power by moving the Switch to the OFF position at any moment during the boiling process.
5. When water is done boiling, pour the water from the Spout by lifting the kettle from the
Base using the Handle. Take care not to touch the stainless steel body, as it will be hot.
CAUTION: Use caution when pouring boiling water from your
kettle, as boiling water may result in scalding.
6. The kettle will not re-boil water when returned to the Base. Press the
Switch to the ON position to begin the boiling process again.
7. When done using, unplug the power cord from the electrical
outlet. Power cord stores conveniently in the Base.
6