Product Overview; Front Panel - LEGRAND C2G Serie Mode D'emploi

HDMI Ultra-Slim HDBaseT + RS232 And IR Over Cat Extender Box Receiver - 4k 60hz

Product Overview

Front Panel

1 2 3 4
F P D
RONT ANEL ESCRIPTION
On: The device is powered on.
1 Power LED
Off: The device is powered off.
Blinking: The device is working properly.
2 Status LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4 Link LED
Off/Blinking: No HDBT link or link error.
Receiver
STATUS HDCP LINK
Rear Panel
6
5 7
R P D
EAR ANEL ESCRIPTION
Locking power port, connect to the DC 18V power adapter provided.
Note: When the receiver is connected to a transmitter with bi-
5 DC 18V
directional PoC function supported, only one power adapter is
needed to be connected to transmitter/receiver to power both units.
6 HDBT IN Connect to the transmitter via a Cat 5e/6/6a/7 cable.
7 IR IN Connect to the IR receiver provided.
8 IR OUT Connect to the IR emitter provided.
9 RS232 For RS232 pass-through.
10 HDMI OUT Connect to an HDMI display using an HDMI cable.
2
Receiver
IR IN
IR OUT TX/RX/G HDMI OUT
8 9
10
(us)
(us)