Safety Warnings; Environmental Information - Seamaid 500743 Manuel D'installation Et D'entretien

6. OPERATION
The system works like an ON/OFF switch, driven by a radio remote controller. First use needs to
proceed to a pairing process between the radio remote controller and the radio receiver installed in the
box.
Pairing process :

Install the battery in the remote controller

Press the black button on the electronic board of the switch (7)

The red LED lights fixedly (8)

Press any button of the remote controller

The red LED flash and stops (8)

The system is ready for use
Remote control function:
On/Off: press O button
Program change: press X button
Channel synchronizing: (ref: 500750)
To synchronize the 4 channels of the switch, press 20 seconds X3 and X4 buttons together till getting
a flashing confirmation of the connected lamps.
To unsynchronized the channels, press 20 seconds O3 and O4 buttons together till getting a flashing
confirmation of the connected lamps.
Metallic parts and electrical devices close to the radio switch can disturb the radio signal. In this case,
it is recommended to install the switch in a better place or add a wired external antenna in option.

7. SAFETY WARNINGS

> Before any operation ensures that the main power supply is turned OFF
> Do not handle with wet feet
> Comply with the current standards regarding accident prevention
> In this regard, the IEC 364-7-702 standards must be observed : WIRING IN
BUILDINGS, SPECIAL WIRING, SWIMMING POOLS.
> The persons in charge of the assembly of this product must have the qualification
required for this kind of work.
8. GUARANTEE
This radio switch is guaranteed 24 months against any material and/or manufacture defect (electronic
components) from the date of delivery. (Keep the purchase invoice/receipt)
The switch is not guaranteed against problems coming from external shock, electric short-circuit or
excessive screwing. The product is not guaranteed against electrical excessive voltage coming from
the external power supply. (In this case, refer to the house insurance coverage)
This guarantee is conditioned with the strict respect of these instructions of assembly and
maintenance. Under this guarantee, the only obligation falling on the manufacturer or distributor will be
the free replacement or repair of the product or the element found defective by their after sale
services. All the other expenses will be the responsibility of the purchaser. For any replacement or
repair, the product must be subjected to an inspection to the after-sales service of the manufacturer or
distributor.
The guarantee does not play in the event of apparent vice.
The defects and deteriorations caused by the fair wear and tear, the defects resulting from a wrong
assembly and/or employment, and the modifications of the product carried out without the written and
preliminary assent of the manufacturer are all also excluded.

9. ENVIRONMENTAL INFORMATION

In accordance with the European Directive 2002/96/CE, concerning the electric and
electronic component scrap (EEED), the consumer must turn over the used product to
the collect points envisaged to this end.