Table des Matières
Publicité
NOTE
Charger does not work at close range. The work
surface thickness must be at least 15mm (0.6")
and no more than 38mm (1.5").
Charging speed will vary depending on the age and
model of your mobile phone and surface thickness.
Surfaces with thickness greater than 30mm may
experience reduced charging speed.
Devices with MagSafe may experience a reduction
in maximum charging range of up to 5mm (0.2")
STEP 1:
Locate the desired position for the charger on
the surface. Measure from there to the edges of
the surface.
STEP 2:
Find the same location beneath the surface.
Ensure that there is adequate room to mount
the charger and adjust position if necessary.
4
①
②
③
Publicité
Table des Matières
