red lion IAMS 0001 Mode D'emploi page 22

Safety readback
When the device is delivered with default configuration, the SIL function is
disabled. The safety readback function (loop surveillance) can be selected in
the menu O.RANGE, thus enabling the device to run in SIL mode. In order to
enable the SIL functionality, the menu item S4...20 mA or S20...4 mA must
be selected. Please note, however, that when safety readback is enabled, a
sensor error will be indicated as an error on the analogue output signal.
Memory
In the memory menu you can save the configuration of the device in the
PGMMOD00, and then move the PGMMOD00 onto another device of the
same type / firmware version and download the configuration in the new
device.
The display module reads the unit when plugged into the unit.
No setup:
Save memory SAVE: Saves the unit's program into the display module.
Load memory LOAD: Loads previously saved program in the display
Loads to display module and exits.
module to the unit.
21