Controls: Filter Change Indicator (Metal Filters) - WindCrest WST300SBG Guide D'utilisation, D'entretien Et D'installation

CONTROLS: FILTER CHANGE INDICATOR (Metal Filters)

Filter Clean Reminder (Standard Metal Filters fitted):
Whether your hood is installed as an Exhaust or Purifying unit, a set of metal fIlters are fitted by the factory. These Metal
Filters are intended to filter out residue from cooking. It need not be replaced on a regular basis but are required to be
kept clean. The Filter Clean Reminder function in the microprocessor will automatically indicate by a flashing
the metal filters are needed to be cleaned after every 30 hrs. of use.
Filters can be cleaned by hand or in a dishwasher with non-abrasive soap. Heavily soiled filters should also be soaked
in grease cutting detergent such as '409' or its equivalent, prior to cleaning.
Filter Clean Reminder:
When flashes on display, the metal filters installed
are required to be cleaned. This will occur after every 30
hours of use.
Re-setting Function:
Reset the Filter Clean Reminder timer when filters are
cleaned and re-installed. Press and hold
seconds until on display disappears
Clean Reminder function is now re-set and a new 30 hours
elapse cycle is initiated.
Set Mode
Clean Filters
To Reset
for approx. 5
hold 5 secs.
. The Filter
15
www.windcrestcnp.com
when
flashes
display <A>
display from <A> to < >