Safety Instructions; Safety Warnings; Specific Safety Rules - VONROC PW509AC Traduction De La Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26

1. SAFETY INSTRUCTIONS

Read the enclosed safety warnings, the additional
safety warnings and the instructions. Failure to
follow the safety warnings and the instructions may
result in electric shock, fire and/or serious injury.
Save the safety warnings and the instructions for
future reference.
The following symbols are used in the user
manual or on the product:
Read the user manual.
Denotes risk of personal injury, loss of life or
damage to the tool in case of non-observance
of the instructions in this manual.
Indicates electrical shock hazard.
DO NOT direct the water jet
towards people or animals.
DO NOT direct the water jet
towards the unit itself, electrical
parts or towards other electrical.
The machine is not intended to be
connected to the potable water mains.
Protect the appliance against frost.
Do not dispose of the product in unsuitable
containers.
The product is in accordance with the
applicable safety standards in the European
directives.

SAFETY WARNINGS

When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric
shock, fire and/or serious injury.
WWW.VONROC.COM
Electrical safety
• Always check if your mains voltage corresponds
with the value on the type plate.
• When replacing old cables or plugs:
• Throw away old cables or plugs immediately
as soon as new ones have replaced these. It is
dangerous to put the plug of a loose cable into
the socket outlet.
• When using extension cables:
• Only use an approved extension cable that is
suitable for the machine's power. The cores
must have a diameter of at least 1.5 mm
the extension cable is on a reel, unroll the cable
in its entirety.
• All electrical connections e.g. extension cable,
must be of an approved waterproof type for
outdoor use and marked accordingly.
Immediately switch off the machine when:
• Interruption of the mains plug, mains lead or
mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.

SPECIFIC SAFETY RULES

The USE and MAINTENANCE manual constitutes an
essential part of the cleaner equipment and should
be kept in a safe place for future reference. If you
sell the cleaner, the manual should be handed on
to the new owner.
• Before starting the cleaner, make sure that it is
receiving water correctly. Operating the cleaner
without water could damage the seals.
• Do not disconnect the plug by pulling on the
electrical cable.
• If you are too far from the object you wish to clean,
do not move the cleaner nearer by pulling on the
high pressure hose; use the handle provided.
• In versions not equipped with TSS device, do
not operate the cleaner for more than 1-2
minutes with the gun closed as this could dam-
age the seals.
• Protect the cleaner from freezing during the
winter.
• Do not obstruct the ventilation grilles during
operation.
• The cross-section of any extension cables
used must be proportional to their length, i.e.
the longer the extension cable, the greater the
cross-section; cables with a protection level of
"IPX5" must be used.
EN
. When
2
5

Publicité

Table des Matières
loading

Table des Matières