Mount With Screws (Optional) - ooma Smart Security Guide De Démarrage Rapide

Mount with Screws (optional)

a. Using the back cover as a stencil, mark the
screw holes with a pencil on the mounting
surface with a pencil. Use a drill to bore holes for
your anchors and place them in the holes.
b. Align the back cover over the screw anchors.
Place screws through the gaps and tighten.
c. Once the back cover is secure, place the sensor
onto it.
d.
Use a small adhesive pad or screw to attach the
water probe where you want it to be. Using the
included adhesives pads or screws, mount the
large device in a place where it will not come into
contact with water (it is not waterproof).
12
(optional)
(optional)
Mount the water sensor probe so that it is either standing up or
laying down in a position that will allow the two gold probes to make contact
with water in the event of a leak.
13