Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mounting Your Sensor
4
Preparing to Mount Your Sensor
After pairing your sensor, you can use either adhesive
pads or screws to mount it.
Before you begin, decide where you want the Water
Sensor to be. Place the tips of the probe where you
expect unwanted water to collect. Unravel the 3-foot
cable to ensure that the main sensor will not get wet.
Mount with Adhesive Pads
(optional)
a.
Use a damp cloth to clean the area where you
want your sensor to be so that the adhesive
pads stick properly.
10
b.
If you haven't already, replace the sensor's back
cover. Then, peel one side of the backing off
the included large adhesive pad. Align it with
the recessed area on the back of the sensor and
press firmly.Make sure front faces are level.
c.
Peel off the other backing paper on the adhesive
pad. Firmly press the adhesive onto the desired
surface for 30 seconds.
d.
Use a small adhesive pad or screw to attach the
smaller water probe where you want it to be.
11
Publicité
Table des Matières
