Maintenance And Storage - Synca rei FM250 Manuel De L'utilisateur

Instructions
Preparation before use
Place the product horizontally on the flat surface.
Keep the product away from audio/video devices such as TV
or radio at least 1 meter to prevent from signal interference.
Instructions
Step 1: Wire connection
Plug the adaptor into the power outlet. (Do not use the unit on other than the designated voltage).
Before connecting the adaptor to the socket, make sure the power
cord and plug are not damaged.
WARNING
Do not plug in the plug with wet hands.
Step 2
Lift off the lid.
Put your feet into the foot and calf massager while seated.
Step 3
Press POWER ON/OFF button on the control panel of the
foot and calf massager, select the desired massage.
Press POWER ON/OFF on the wireless lumbar massager;
slide it behind you to enjoy the massage.
After use
Turn off the power switch on the control panel.
When the unit is not in use, always unplug the
unit from the outlet.

Maintenance and Storage

Maintenance
Clean
Before cleaning, make sure the power switch is turned off and the power plug is unplugged from the outlet.
Wipe the surface of the product with a soft dry cloth.
If the product is dirty, wipe the unit with a dry cloth moistened in diluted neutral detergent or water and
thoroughly wrung out, and then use a dry cloth to wipe the unit again. Thereafter, allow the unit to dry
naturally.
Do not pull the zipper too hard when removing the detachable cloth cover to avoid damage.
Wash the cloth cover with a neutral detergent.
WARNING
Do not plug in the power plug with wet hands.
Do not rinse the product with water or get water or other liquids inside of the product.
Do not use benzene, thinner, alcohol, solvents or abrasives to avoid scratch, discoloration
or cracks on the surface.
Maintenance
Prior to the maintenance work, make sure to power off the product and disconnect the power plug from the outlet.
Keep the unit clean and away from humidity and high temperature environment to avoid moisture and dust.
When the unit is not being used for a long period of time, place a cover over the unit to protect it from dust.
WARNING
Do not place the unit in areas exposed to direct sunlight, or near heaters, hot air blowers or any other
heating devices to avoid discoloration or deterioration on the surface of the holster.
Tips
Always pay attention to the following when the product has been used for years:
Scorched smell.
When the power cord is touched, the power is sometimes on and sometimes off.
The power cord is hot.
Other anomalies.
DANGER
Stop using the product to prevent from malfunctions and accidents if above situation is observed.
Turn off the power switch, unplug the power cord and contact the dealer or its service agent.
Do not disassemble and repair the product by yourself.