Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
• Expose everyone to the sound of the smoke alarm and heat alarm and
explain what the sounds means.
• Determine TWO exits from each room and an escape route to the out-
side from each exit.
• Teach all household members to touch the door and use an alternate
exit if the door is hot. INSTRUCT THEM NOT TO OPEN THE DOOR IF
THE DOOR IS HOT.
• Teach household members to crawl along the floor to stay below
dangerous smoke, fumes, and gases.
• Determine a safe meeting place for all members outside the building.
WHAT TO DO IN CASE OF A FIRE
1. Don't panic; stay calm.
2 . Leave the building as quickly as possible. Touch doors to feel if they
a re hot before opening them. Use an alternate exit if necessary.
Crawl along the floor, and DO NOT stop to collect anything.
3. Meet at a prearranged meeting place outside the building.
4. Call the fire department from OUTSIDE the building.
5. DO NOT GO BACK INSIDE A BURNING BUILDING. Wait for the fire
department to arrive.
These guidelines will assist you in the event of a fire. However, to reduce
the chance that fires will start, practice fire safety rules and prevent
hazardous situations.
TROUBLESHOOTING
!
D A N G E R :
Always turn off power at main fuse box or cir-
cuit breaker before taking trouble- shooting
a c t i o n .
!
WA R N I N G :
DO NOT disconnect battery or AC power to
quiet an unwanted alarm. This will re m o v e
your protection. Fan the air or open a win-
dow to remove heat or dust.
P R O B L E M
Heat alarm does not
sound when tested.
NOTE: Push test button for
at least five (5) seconds
while testing!
Heat alarm beeps about
once a minute.
Heat alarm sounds
unwanted alarm s .
I n t e rconnected heat
a l a rms do not sound when
system is tested.
REPLACE OR RETURN THE ALARM IF THE PUSH-TO-TEST
FUNCTION DOES NOT OPERATE PROPERLY AFTER FOLLOWING
THE PROCEDURES OUTLINED ABOVE (see REPAIR on page 6).
S O L U T I O N
1 . Check that AC power is
t u rned on.
2 . Tu rn off power. Remove heat
a l a rm from mounting plate
mounting plate and:
a . check that connector
plug is securely attached.
b . check that battery is
p roperly attached to
c o n n e c t o r.
3 . Clean heat alarm .
Tu rn off power and replace battery
See "Battery Replacement" in the
MAINTENANCE AND
CLEANING section.
1 . Clean heat alarm .
See "Cleaning" in the MAINTE-
NANCE AND
CLEANING section.
2 . H i re an electrician to
move heat alarm to a new
location. See HEAT ALARM
P L A C E M E N T.
1 . P ress and hold test button
for at least three seconds after
after the first unit sounds.
2 . Tu rn off main power or circ u i t
b reaker and check the inter-
connect wiring. See INTER-
CONNECTING HEAT ALARMS
section of this manual.
7
Publicité
Table des Matières
