Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PANIC
To activate the panic mode, press either
or
This command activates all deterrents that are connected to the system, parking lights, horn, siren and dome light for
30 sec.
or 60 sec.
depending on programming made during installation.
Panic mode is used to attract attention if you are experiencing difficulties.
If you are inside the vehicle when Panic Mode is activated, press on the brake pedal to lock doors (optional connections
required) and neutralize antitheft (60 sec. if doors were already locked). As long as the cycle is not over, applying the brakes
resets the sequence from the beginning every time.
This command will not be executed if engine is kept running by ignition key.
Press the
button to abort panic mode.
START FAIL CODES
When a remote start attempt fails, it is possible to determine what caused the failure to start.
Press (2 sec.) on the
button, then press the
parking lights flash corresponds to the start fail code.
The table below lists the various start fail codes.
Code
1
Module has received a Stop command (remote or timer).
2
Brakes were applied during or after start sequence or module overload occurred.
3
Stopped by alarm.
4
Engine does not crank when starting sequence is initiated.
5
Start command ignored because hood is open.
6
Safety sequence not valid during start sequence.
7
Start command ignored because key is in ignition (in 'Run' position).
8
Remote starter main switch is OFF.
9
Runtime has elapsed.
10
Remote starter attempted to start engine three times unsuccessfully.
11
Remote starter sensed engine was already running.
12
Engine is over-revving (RPM > 3000)(programmable at time of installation).
13
Engine not cranking fast enough during start sequence.
14
Security sequence has been invalidated by status of parking brake.
15
Security sequence has been invalidated by opening of one or more doors.
16
Consult your dealer.
19
Consult your dealer.
20
Consult your dealer.
If any of these start fail codes persist, consult your dealer.
18
button and hold for more than 4 seconds.
and
buttons simultaneously (2 sec.). The number of times the
Failure to start details
Publicité
Table des Matières
