Switching On And Off; Permanent Operation - Tyrolit HGE125 Notice Originale

HGE125
7

Switching on and off

!
-
8 Changing the Diamond Grinding Wheel
Attention!
The grinding wheel might heat up enormously during operation.
You could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the grinding wheel.
Before any work on the tool, disconnect the plug from the mains!
First of all, the detachable hood segment has to be opened.
Now you can hold up the driving disc between gearbox and grinding wheel by using a
jaw wrench 32 (1). Use the face spanner (2) to unscrew the driving nut. Then remove the
mounted grinding wheel respectively mount the new one.
The assembly works the other way round.
Let the machine run for a short period of time and in a safe position. If the machine does
not run easily, stop working immediately.
Use only original accessory!
Short-Time Operation
Switching-on: Press the on/off switch twice within 2 seconds.
Switching-off: Release the on/off switch.

Permanent Operation

Switching-on: Press the on/off switch twice within 2 seconds and, keeping
it pressed, engage the lock-on button.
Switching-off: Press the on/off switch and release it again.
Attention!
Pressing the switch twice serves as restart protection.
The restarting protection feature prevents uncontrolled
restarting of the machine after an interruption in the power supply. To restart the
power tool, place the on-off switch to the off position and switch the power tool on
again by pressing the switch twice.
The HGE125 is equipped with an adjusting wheel in order to allow a stepless variable control
+
of speed from 6000 to 10000 rpm. The adjusting wheel is on the top side of the handle
opposite of the on/off switch.
A permanent use with reduced speed can cause an overload because the motor
then gets less cooling air and therefore the machine will be overheated much faster.
A thermal switch-off can be released!
en
2
19
1