SportTec PULL-UP 6.0 Mode D'emploi page 10

ASSEMBLY
Please note:
Before assembling the pull-up bar, first read through all the instructions carefully.
Before installation, please ensure that the door frame is not damaged, that it is suitable for mounting the door
bar (real wood doors, security doors) and that it has sufficient load-bearing capacity. Do not mount between glass
surfaces and other unstable surfaces.
Please note that the maximum load-bearing capacity may not be identical for all door frames. The load-bearing
capacity always depends on what the door frame is made of.
❷
❶
Place the pull-up bar on the floor in the desired door frame.
Unfasten the two red clamps ❶ from the grip ends ❷ and pull
them outwards so you can adjust the length of the pull-up bar.
Now slide the pull-up bar to the desired position in the door
frame. Make sure that the bar is placed horizontally in the door
frame.
Now twist the middle bar in the direction of the arrow until the
bar is firmly in place in the door frame.
10
Sport-Tec GmbH ∙ Physio & Fitness ∙ www.sport-tec.de
❸
❸
Now adjust the length of the pull-up bar to the width of the door
frame by unscrewing both ends of the pull-up bar ❸ until the
bar is in contact with the door frame. Be sure to unscrew both
ends evenly.
Tip: screw in the direction of the arrow to increase the length of
the bar and in the opposite direction to shorten it.
❷
❶
Put the red clamps ❶ on the grip ends ❷ on both sides to
secure the pull-up bar. Make sure that the pins of the clamps
fully engage with the receptacles on the bar. To do this, it may be
necessary to twist the bar a little more.