Driving Guidelines; Preparation; Important - Motus Scooty 10 Manuel D'utilisation Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
4.5 The driver's weight must exceed 45 kg
To guarantee safety against children, all drivers must weigh over 45 kg. If the
driver's weight is less than 45 kg, the vehicle can operate incorrectly.
4.6 Battery level
The battery level is displayed at the position marked in Scheme 1B with the letter
F.
The driving range will decrease during the winter because battery performance
will quickly decreases in low temperature conditions. For example at tempera-
ture -15 ° C battery performance is halved compared to performance in room
temperature. To ensure battery life during winter, it should be charged and
unloaded at least once a month.
NOTE: If the vehicle slows down drastically and the wheels start shaking, it will
meant that the battery level is very low. Then you should immediately release
and get off the vehicle safely. Then turn off the vehicle. In that situation, do not
drive the vehicle until recharged battery.

5. DRIVING GUIDELINES

5.1 Preparation

Make sure you have a comfortable outfi t before starting your fi rst ride infor-
mal or sporty and fl at footwear. You should take care more space and make
sure there aren't any larger ones obstacles. It is recommended to put on
protectors to protect against accidents.
If you notice that you need more air in the wheels, use a pump to adjust
the pressure. NOTE: Excessive pressure may cause wheel breakage. Driving
without air in the wheels can also damage the wheel. The optimum tire
infl ation level is 3.8 Bar.
BRAKE ADJUSTMENT: If you think the brakes are too strong, use a wrench
counterclockwise hexagon, to loosen the screws on the pressure plate on
the brake seat. Release the brake hose to slightly shorten the exposed
length and tighten the platen screws. If you think the brake is too loose, re-
lease the screws on the pressure plate, pull the brake cable to slightly extend
its length and then lock the screws on the pressure plate.
IMPORTANT: At fi rst the brakes may rub slightly, This is normal.After trave-
ling a few km, the brake will adapt and the friction will disappear.
10
EN
ADJUSTMENT OF THE FOLDING MECHANISM
If you think the steering wheel is not stable enough, use a suitable wrench to
tighten the screws on the folding mechanism.
5.2 Start driving
Make sure the folding mechanism is fully secured.
Step 1. Start the vehicle by pressing the power button. After at the moment
the vehicle will be ready for use.
Step 2. Place the feet on the platform correctly. Push away to enter scooter
in motion and press the throttle control. Steer the vehicle by keeping center
of gravity to maintain balance. Remember not to make sudden movements
of the body.
Step 3. Press the throttle grip (Diagram 1A: C) down to accelerate.
Step 4. Press the brake handle (Diagram 1A: A) down to brake.
Step 5. Getting off the vehicle: stop before leaving the vehicle vehicle.
5.3 Land and purpose
1. The vehicle is designed to ride on smooth and fl at surfaces. To prevent
loss of adhesion, always keep it caution when driving and learn to recognize

Publicité

Table des Matières
loading

Table des Matières