Important; Basic Safety Precautions - VITO PRO-POWER Mode D'emploi

Masquer les pouces Voir aussi pour PRO-POWER:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

ImPORtANt

Always read the instructions before
you start using your power tool.
bAsIC sAFEtY
PRECAutIONs
1. Keep the work area clean. A clut-
tered site can cause damage.
2. Do not use power tools in damp
or wet locations. Do not expose
power tools to rain.
Keep the workplace well lit. Do not
use in locations with gas / flam-
mable liquids.
3. Do not allow children to remain
close to the workplace.
All people should stay away.
4. You should keep all tools in a dry,
high and locked.
5. Get a job with better quality if
the suit the speed of the machine.
Avoid unnecessary burdens that
may endanger the operator and the
power tool.
6. Do not force small tools and
accessories to perform the work of
larger machines, and do not use for
work inadequate.
7. Do not wear loose clothing or
jewelery, they can become trapped
in the tool. We recommend the use
of gloves and work shoes. Long hair
should also be arrested.
8. Always use eye protection. If
dust, also use mask.
10
9. Do not hold the tool by the cord.
Should not turn off the electrical
current to stop the tool. This proce-
dure should be done on the switch.
Keep cord away from heat, fuel and
sharp edges.
10. Keep yourself in balance.
11. Keep tools clean for better and
safer performance. Follow the
maintenance instructions.
Inspect cords regularly and replace
them if damaged. Keep your hands
dry, clean and free of oil.
12. Disconnect the tool from the
mains when not being used.
13. Get used to check that adjusting
keys are with the power tool.
14. If the tool is connected to the
mains, do not transport with fingers
in contact with the switch. On the
other hand, make sure the switch is
off when plugging in the mains.
15. If you need an extension make
sure that the wire of the same sec-
tion has a size equal to or greater
than the cable from the power tool.
16. Stay alert, attentive to his work,
and use common sense. Do not
continue to work if you are tired.
17. Before starting work with any
tool, must prove that there is no
damaged parts. Carefully check the
installation and tuning of all moving
parts.
18. Any damaged part should be
properly repaired or replaced by a
qualified technician. Do not use the
tool if the switch is not working.
19. The use of an accessory inap-
propriate represents a potential risk
to the user.
20. This tool complies with the
safety regulations in force. Your
repair should only be performed by
a qualified technician. Otherwise,
the risk to the user is real.
PRECAutIONs IN usING
tHE PREssING dRIll
- Make sure the chuck is properly
tightened.
- Secure the base of the drill on a
solid and flat.
- Never loosen the chuck by hand.
Do not use any other accessory that
no drill.
- After tightening the drill Always
remove the chuck key, and do not
lock in any part of the machine.
- Always work with speed adapted
to the work to be performed.
- It is MANDATORY that the work-
piece is tight around the set on the
table, in order to avoid injury from
the release part.
- Periodically check the tightness of
bolts and nuts.

Publicité

Table des Matières
loading

Table des Matières