Instructions For Safety And Use - Novy 990036 Instructions D'installation

EN

1 INSTRUCTIONS FOR SAFETY AND USE

Further information on Novy products, accessories and
services may be found on the internet: www.novy.co.uk
These are the installation instructions for the appliance
shown on the front.
These directions for use make use of a number of symbols.
The meanings of the symbols are shown below.
Symbol Meaning Action
Indication Explanation of an indication on

the device.
Warning This symbol indicates an


important tip or a dangerous
situation


Warnings before installation
− Carefully read the safety and installation instructions of
this accessory and of the cooker hood with which it can
be combined before installing and using it.
− Check on the basis of the drawing A that all the materials
for installation have been supplied.
− The appliance is intended exclusively for household use
(preparation of food) and excludes all other domestic,
commercial or industrial use. Do not use the appliance
outside.
− Keep good care of this manual and pass it on to any
person who may use the appliance after you.
− This appliance complies with the applicable safety in-
structions. However, inexpert installation may cause
personal injury or damage to the appliance.
− Check the condition of the appliance and the installation
fittings as soon as you remove them from the packaging.
Remove the appliance from the packaging with care. Do
not use sharp knives to open the packaging.
− Do not install the appliance if it is damaged, and in that
case inform Novy.
− Novy is not liable for damage resulting from incorrect
assembly, incorrect connection, incorrect use or incorrect
operation.
− Do not convert or alter the appliance.
− Metal parts may have sharp edges, and you may injure
yourself on them. For that reason, wear protective gloves
during installation.
1 Connecting cable extractor
hood and I/O module
2 Connector I/O module
to device
3 Output connector
4 Input connector
Contact Function
INPUT for Start / stop extraction by means
cooker of a window switch when the
hood cooker hood is set to duct­out
mode.
Cooker hoods:
If the window is not open, the
extractor fan will not start. The
green and orange LEDs of the
grease and recirculation filter
indicator (cleaning / replacement)
will flash.
After opening the window, the
extraction starts and the LEDs
stop flashing.
In the case of worktop
extractors
If the window is not open and the
extraction tower is switched on,
the extraction will not start. The
LEDs next to the grease filter and
recirculation filter indicator will
flash.After opening the window
the extraction starts and LEDs
stop flashing.
When the cooker hood is swit-
OUTPUT
ched on, the potential-free con-
for coo-
tact closes from the I/O module.
ker hood
Here, for example, an extra valve
for external air supply / extraction
can be controlled.
Max 230V - 100W


(*) Potential­free contact remains closed for 5
minutes after stopping the cooker hood
5
990036
3
4
1
Contact
Open potenti­
al­free contact:
start extraction
Closed
potential­free
contact:
stop extraction
Closed
potential­free
contact:
stop extraction
Start
extraction:
closed
potential-free
contact
Stop
extraction:
open
potential-free
contact (*)