Kronos pH/ORP Manuel D'installation page 6

Paragraph 2 – Proportional dosing for the pH measurement (factory default)
Programming
PROG
Config.
Config.
Funct.
Funct.
pH
Setpoint
7.00pH
Set.Type
Acid
Pro.Banda
0.50pH
AlarmBand
0.50pH
OFA
0m
Calibr.
Probe
Temp.Man Temp.Man
25°C 25°C
Temp.Man
77°F
0000138014
The pump measures and controls the pH value of a solution, by
programming
proportional band and alarm band.
Set-point type: acid
s/m
max
flow-rate
0
Set-point type: alkaline
s/m
max
flow-rate
0
Can also be programmed:
- The O.F.A. (Over Feed Alarm) time in minutes, a set period of time after
which, if the measured pH does not reach the set-point, an alarm signal
is activated.
- Activation / deactivation of the calibration procedure
- Manual temperature value in °C (default) or °F
Display during operation
Alarms and statuses
• Cal = Calibration not
performed
• Lev = Level Alarm
• Flw = Flow Alarm
•
• Alm = Mesure out Band
•
Alarm
•
• OFA = O.F.A. Alarm
•
rev. 1.0 EN
Operation
the following parameters:
Proportional
Pump Off
Alarm Band
P roportional
Band
Alarm Band
7.00pH
pH measure value
P 100%
Value of dosing on going
(depends on unit of measure
Pump status
Percentage, Frequency,
•
empty = pump in stating
l/h, Gph, ml/m
Stop = pump in stop
•
Paus = pump in pause
set-point,
Band
14
Alarm Band
Pump Off
14
Alarm Band
selected)
set-point type,
pH
pH
4