Restore Factory Settings - Garden Lights ARCO40+ Mode D'emploi

EN
The Garden Lights Arco Plus is a smart light, for use in combination with the Garden Lights 12-volt
outdoor lighting. To operate the smart lights, the (free) Garden Lights app should be installed on a suitable
smartphone or tablet. For more information on how to download and use the app, go to
www.garden-lights.com/en/smart.
[!] Make sure all parts are included in the packaging. You can always contact us with any questions you
may have about parts or service, as well as complaints or other matters. Email: info@garden-lights.com.
Use
When installing the Arco Plus, keep in mind the following regulations:
1 The Arco Plus must be connected to a 12-volt Garden Lights system with a permanent voltage supply.
2 The Arco Plus cannot be used in combination with the following accessories:
- Motion Sensor (art.nr. 6156011)
- Receiver (art.nr. 6148011 and 6149011)
3 When placing the smart lamps, consider the distance to the smartphone. The lamps have a good
connection up to 16 meters. If the distance increases, the signal slows down.
4 The smart lights amplify the Bluetooth signal to each other. For proper operation, place the light up to a
maximum distance of 20 meters from each other.
5 The Arco Plus cannot be placed behind a Switch Plus (art.nr. 6269011) because it must be
continuously supplied with power.

Restore factory settings

In the event of a malfunction, or if you have forgotten your password (set via the app), the Arco Plus can
be reset to factory settings. To do this, proceed as follows:
[!] Warning: This will reset all Garden Lights Plus lights in your system to factory settings. Disconnect any
lights whose settings you want to keep from the main cable before starting!
1 Make sure the system is supplied with power.
2 Leave the lights on for a minimum of 15 to a maximum of 20 seconds.
3 Disconnect the power from the system (for example, by unplugging the transformer from the electrical
outlet).
4 Wait a minimum of 5 to a maximum of 10 seconds.
5 Reconnect the system (plug the transformer back into the power outlet).
6 5Repeat steps (2) to (5) several times.
7 When steps (2) to (5) have been correctly followed three times in a row, the Garden Lights Plus lights
will flash red several times.
8 Wait until the lights stop blinking and light up white. The factory settings have now been restoreand the
lights are ready for use again.
SMART
7