Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual KSK-3201 RF/ BT
5.3 Keyboard installation KSK-3201 RF
•
Recommended requirement is the successful installation of the USB receiver under point 5.2.
•
If you haven't done yet, remove the covering of the battery case on the bottom of your keyboard. Install the
included batteries of type AAA 1.5 V considering the right polarity in the battery case (see picture).
•
Switch ON the On/Off sliding switch on keyboard's back side
•
The USB receiver and the keyboard are factory-made already synchronised on the same channel. Nor-
mally you have not to make a new-synchronisation (as described under point 5.4).
•
Now you can check this by pressing any key of your keyboard.
If you press the Windows key, for instance, the Windows Pop-up
menu down left on your screen has to open. If so, your
wireless keyboard is working correctly now. If not, please
synchronise the USB receiver and the keyboard again like
described under point 5.4.
Advise: Should the functionality be infl uenced by other users applying their wireless keyboard close-by,
make a newsynchronisation as described under point 5.4.
5.4 New-synchronisation of the radio channel KSK-3201 RF
•
When you install your keyboard for the fi rst time and no connection can
be established, please synchronise the radio channel between key-
board and USB receiver again by pressing and holding the keys
+ F1) simultaneously. After 2 seconds pairing starts, the pairing LED
is blinking. Pairing can take several seconds and is fi nished, when the
LED above the trackball goes off. Now the keyboard is ready for usage.
Check now the functionality of the keyboard as described under
point 5.3.
In implausible case the keyboard does not work even after new-
synchronisation, you have the following options to solve this problem:
•
Repeat the procedure of synchronisation as described under 5.4.
Sometimes it is necessary to repeat this routine several times, until the right radio channel is found.
•
In case your USB receiver is attached to an USB hub, you should install it directly on the USB connector
of your notebook or desktop.
•
During the procedure of synchronisation the keyboard should be located close to the USB receiver to
make sure, that the immediate environment has no infl uence on the radio transmission (for instance
reduction/ interferences due to metal cases, other sources of interferences etc.).
•
Ensure that you use only batteries with full loading capacity. In case of doubt change
the old batteries before next synchronisation against new ones as a precaution.
Low battery capacity is signalised by permanant glowing of the blue LED above the
trackball.
Errors & omissions excepted
2 x
!
(Fn
Pairing LED
Low Battery LED
14
Publicité
Table des Matières
