Table des Matières
Publicité
9. Error display
The YFC-35D controller shows error code number when it detect any failure during operation.
The error code are as below
No
Code
1
101
Screwdriver not connected
SMPS fault.
2
111
The power supply system will
be shut down by overload
3
112
Overload protection
4
113
Over Temperature protection
5
114
Over Speed error
Description
- 20 -
Trouble shooting
Check the cable connection
Turn off the power and On again after
1 min.
Automatic reset. refer to 5.2 protection
Automatic reset. refer to 5.2 protection
When the speed monitored over the
target, it show E114.
Check motor condition.
Publicité
Table des Matières
