Assembly; Connect The Hoses; Priming The Pump - Generac 7126 Manuel Du Propriétaire

Assembly

WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.

Connect the Hoses

CAUTION
Equipment damage. Use only hoses and couplings
designed for this pump. Incorrect hoses and
couplings can cause performance issues and
permanent equipment damage.
NOTE: Appearance of pump may vary.
Discharge ports face 90° from inlet on certain
models.
NOTE: Hose kit may be sold separately.
1. Place water pump in desired operating
location.
2. Attach the flexible discharge hose to the
flange (top) by sliding the hose over the
barb and securing with a hose clamp.
3. See Figure 2-5. Attach the suction hose to
the flange (bottom) by sliding the hose
over the barb and securing with a hose
clamp.
NOTE: Hose attachment styles may vary.
Figure 2-5.Typical Hose Attachment
4. See Figure 2-6. Attach the strainer to the
suction hose.
Figure 2-6.Typical Strainer Attachment
CAUTION
Equipment damage. Use recommended strainer to
prevent debris from entering the pump. Failure to do
so could result in equipment damage.
6

Priming the Pump

Equipment damage. Before starting engine, verify
pump is primed with water and suction strainer is
submerged. Failure to do so will cause pump damage
and void the warranty.
(000100a)
Remove the orange priming cap from the
pump and completely fill the pump chamber
with clean water. Tighten the cap. DO NOT
over tighten.
(000197)
001516
001517
(000241)
General Information and Setup
CAUTION
Figure 2-7. Water Priming Plug
Owner's Manual for Water Pump
(000203)
001513