F.B. SUBMERSIBLE MOTORS 6 Manuel De Montage Et D'utilisation page 19

.
Handling
Unpacking
Disposal
→
→
→
After having unpacked the submersible electropump check for any damages like, for
instance, on the diaphragm cover, outer casing, connections or motor cable.
→
If damage is found report it immediately to the supplier.
_____________________________________________________________
If the motor cable is damaged there is a risk of death due to electric shock.
Do not install the motor or turn it on.
_____________________________________________________________
Do not leave the motor without liquid inside as it could cause the rotor to jam.
Do not install the motor or turn it on.
_____________________________________________________________
→ For safe storage after a previous installation, the electropump must be thoroughly cleaned (never
ever use hydrocarbon based products for this purpose). The hydraulic part must be dried inside
with a jet of forced air.
To avoid damaging the environment:
Prevent contamination due to lubricants, detergents, etc.
•
• Dispose of the submersible electropump and packaging materials in accordance with the
law and with respect for the environment.
•
Comply with local laws.
Comply with the storage temperature (from –15 to +50°C, see the
technical data sheet).
For temperatures below -15°C the concentration of polypropylene
glycols will have to be increased (e.g. a concentration equivalent to
50% for a minimum temperature equal to -35°C).
19
EN