Carbon Brushes; Setting And Use - Sima MIX-PRO 1600 Manuel D'utilisation

10.1 CARBON BRUSHES

Inspect carbon brushes once a month. The normal life of carbon brushes is 200 hours. Proceed to replace if the length
is less than 6mm
NOTE: Worn out brushes will result in the loss of power, the engine overheat and damage the housing will be
irreparab le.
To chang e carbon brushes proceed as follows:
1. Unplug the unit.
2. Unscrew bo th ends of carbon brushes.
3 . Replace the brushes.
4. Re-threading the tops of the brushes

11. SETTING AND USE.

CAUTION: Do not put up the electric mixer if it not submerged in the liquid mixture or mixing. If you enter
the mixer paddle in action it can splash the mix product.
To start the electric mixer proceed as follows:
1. Mount the mixer paddle at the motor shaft
2. Connect the machine to the network
3. Select the lowest gear ratio possible to gain control
4. Enter the mixer paddle in the mixing container where the mix is.
5. Press the unlock switch button stop / start.
6. Press the switch stop / start.
7. Increase the speed with speed driver if required.
Mixing materials
The choice of mixer paddle depends on the viscosity of the mixture. Substances with a low viscosity, such as paint,
varnish, cement, cement glue sealing require a mixing paddle with a left turn. Substances with a high viscosity, such
as ready-mixed plaster, concrete, cement, metal, putty and epoxy resin, a mixing paddle will require a right turn.
While the liquid is mixing, it is important to keep the mixer paddle in the mix. The machine should move up and down
motion to ensure that all materials are properly mixed. Never expose the tip of the blade above the liquid.
After finishing the mixture has to wait until the blade stops spinning completely before removing from the mixture. The
mixing paddle should be cleaned immediately after use to avoid adhering to dry and remain disabling the mixing
paddle.
All manuals and user guides at all-guides.com
-8-
ENGLISH