Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
1.
Carefully unpack unit and examine all packaging to make sure all parts are
included (See page 2)
2.
Clean all parts prior to using.
3.
Place unit on a flat stable surface.
4.
Make sure Switch is "OFF" (O) and power cord unplugged before assembling.
5.
Turn Locking Screw counter-clockwise several turns. Insert Grinder Head into
Base opening until seated and tighten Locking Screw.
6.
Insert Feed Screw into Grinder Head, long end spindle first. Turn slightly until
fully set in Grinder Head.
7.
Position Cutting Blade (cut edge facing outward to plate) onto Feed Screw. Make
sure blade is seated over 'square' shoulder of Feed Screw or meat will not grind
properly and Cutting Plate may be damaged.
8.
Place desired Cutting Plate over end of Feed Screw and against Blade. NOTE:
Make sure "notch' is aligned with 'key' in Grinder Head and seated against Blade.
.
Thread Ring Nut on Grinder Head and turn clockwise until tight.
10.
Place Food Hopper on top of Grinder Head.
11.
Plug into 120 V outlet and you are ready to begin grinding.
Operating Instructions
1.
Place the unit on a flat and stable work surface. Be sure unit is fully
assembled (see Assembly Instructions).
2.
Make sure the Switch is in the "OFF" (O) position.
3.
Insert plug into standard 120 Volt electrical outlet, rated 15A minimum.
4.
Place a wide, shallow bowl or plate beneath the Grinder Head to catch
ground food.
5.
Press Switch to "ON" (I). Always have the unit running before adding
food.
6.
Cut food into strips or cubes slightly smaller than the Hopper opening.
7.
Place food into the Hopper and use Pushrod to gently feed food into
the Feed Screw. Do not force food into the Grinder Head and NEVER
use fingers or other tools, other than recommended by appliance
manufacturer, to feed food into Grinder Head.
8.
If the motor slows or stops, this may be due to jammed food. See
instructions below for clearing jammed foods. IMPORTANT - NEVER PUT
YOUR FINGERS INTO THE FOOD HOPPER OPENING WHILE UNIT IS
OPERATING OR PLUGGED INTO ELECTRICAL OUTLET.
.
When you have finished grinding food, press Switch to "OFF" (O), unplug
from electrical outlet and follow cleaning instructions.
3
Publicité
Table des Matières
