Noise And Vibration; General Information; Machine Operation - NSS Enterprises Alpha 8 Instructions D'origine

NOISE AND VIBRATION

NOISE - ALPHA 4
Sound pressure level at Operator
position (ISO 11201)
NOISE - ALPHA 8
Sound pressure level at Operator
position (ISO 11201)
NOISE - ALPHA 16
Sound pressure level at Operator
position (ISO 11201)
NOISE – ALPHA 24
Sound pressure level at Operator
position (ISO 11201)

GENERAL INFORMATION

 Now that the machine is unpacked remember to
recycle all packing materials.
 Inspect the machine for damage or missing
components. If damage is found, contact the local
freight company to file a freight claim.
ASSEMBLY
Installing the Hose
 Push in on the intake button, on the side of the
intake, then, insert the end of the hose into the
intake opening until it stops.
 To remove push in on the intake button, grasp the
coupling and pull.
Attaching Wands and / or Tools
 Choose the proper tool for the operation being
performed. Squeegee tool, for wet pick up. Brush
tools, for bare floors or dusting. Crevice, or carpet
tools.
Chrome Steel Wand
 When assembling the 2-pieces be sure to line up
the indicators prior to connecting the parts
together.
 The top end of the upper half of the wand connects
to the hose.
 The bottom end of the upper half fits over the upper
end of the lower half of the wand.
 Connect the proper tool to the bottom of the bottom
half of the wand with a friction fit.
72 dB(A)
72 dB(A)
72 dB(A)
72 dB(A)
Optional Front Mount Squeegee
The squeegee mounts to the base of the machine
and is used for vacuuming large areas of water spills,
or to pick up excess liquids after stripping floors.
Dusting
For overhead areas use the two-piece tube kit. For
routine dusting attach the dusting brushes, or crevice
tool directly to the end of the hose.

MACHINE OPERATION

With the switch in the off position, plug the electrical
cord into an approved outlet (See page 2). To turn
the machine on, use the switch located on the lid of
the machine.
Wet Pick Up
 Remove the polyester filter for wet pickup.
 Empty the tank
 As the liquid level rises the built-in float will be
activated. The built in float will not be activated by
foam.
 The motor will speed up and sound different when
the airflow is closed off.
 Turn the vacuum off and drain liquids according to
your local government regulations.
 NSS recommends that you always use a defoamer
agent along with low foaming chemicals diluted
according to manufacturer's specifications in order
to protect the vac motor. If the vacuum motor is
flooded with liquids or foam immediately turn the
motor OFF.
 Consult your local distributor for complete chemical
advice.
 When using the wand with the squeegee tool on
floors, the operator should drop his / her arm
slightly to allow air to enter the front edge of the
tool on the forward stroke. On the backward stroke
the operator should raise his / her arm slightly to
allow the back edge of the tool to clear the floor.
This method gives the air a chance to do the work
in the most effective manner.
 The operator should make strokes at a leisurely
pace and at a length that feels the most natural.
 Always work away from the machine, pulling the
machine behind you.
Dry Pick Up
 Dry soil can be vacuumed directly into the tank.
 Clean or replace the filter bag when suction is
reduced.
 Choose the proper wand and / or tool.