X4-Life 701765 Mode D'emploi page 16

DANGER! Short-circuit hazard! A short-circuit could be
caused if moisture enters the product.
» Never immerse the product into water.
» Take care that no liquids enter the casing of the product
Installation
DANGER! Disregarding can cause material damage.
Before installation, check if the chosen surface is suitable
for the fastening clips and is able to support the weight of the
product. For installation always use the items included with
the product. Do not use any sharp objects such as nails or
fasteners. Ensure that you do not strike any electrical wires,
gas or water pipes in the desired spot of installation when
drilling.
If you are unsure about any of the steps, please seek advice of
an electrician.
For the best results we recommend marking the positions for
the drillholes lightly with a pencil and if available use a spirit
level as a guide.
1. Drill the holes into the desired spot.
2. Insert the included dowels into the drilled holes.
3. Fix the fastening clips to the wall with the included screws.
4. Push the LED-Strips lightly into the fastening clips. Please
be careful not to bend the strips by applying too much
force. Make sure that when attaching the strips, the mains
adapter stays unplugged.
5. Connect the LED-Strips to the connector cables and mains
adapter.
16