Shutting Down - PowerWasher PW2623C Manuel D'utilisation

11
C
6. Connect water source (N) to pump
inlet (J). NOTE: Water source must
provide a minimum of 5 gallons per
minute at 20 psi.
12
N
WARNING:
possibility of contamination always
protect against
connected to a potable water system.
7. If applying a chemical or cleaning
solution, see how To Apply
Chemicals/Cleaning
instructions in this section.
8. Turn water source on.
NOTICE: Risk of property damage.
Failure to do so could cause damage
to the pump.
9. Remove all air from the pump and
high pressure hose by depressing
trigger until a steady stream of
water is present.
10. Start engine. See Engine Owners
Manual for correct procedure.
WARNING:
operation. If engine does not start
after two pulls, squeeze trigger of
gun to relieve pump pressure. pull
starter cord slowly until resistance
is felt. Then pull cord rapidly to avoid
kickback and prevent hand or arm
injury.
11. Depress trigger on gun to start
water flow.
I
J
To reduce the
backflow when
Solvents
Risk of unsafe
WARNING:
operation. Stand on a stable surface
and grip gun/spray wand firmly with
both hands. Expect the gun to kick
when triggered.
12. Release trigger to stop water flow.
WARNING:
Risk of
from spray.
Always engage
the trigger lock
(O) when gun is
not in use. failure
to do so could
cause accidental spraying.
13. Adjust nozzle spray for the task
being performed. See how To Use
spray Wand instructions in this
section.

ShUTTING DOWN

1. After each use, if you have applied
chemicals, place detergent siphon
hose into container of clean water
and draw clean water through
chemical injection system to rinse
system thoroughly.
NOTICE: Risk of property damage.
Failure to do so could cause damage
to the pump.
2. Turn engine off. See Engine
Owner's Manual.
NOTICE: Risk of property damage.
NEVER turn the water off with the
engine running.
3. Turn water source off.
4. Pull trigger on spray gun to relieve
any water pressure in hose or spray
gun.
5. See Storage section in this manual
for proper storage procedures.
mAINTENANcE
WARNING: Risk of burn hazard.
When performing maintenance, you
may be exposed to hot surfaces,
water pressure or moving parts that
can cause serious injury or death.
15 - ENG
Risk of
injury
13
O
unsafe