Child Craft Bristol F99040 Guide D'assemblage page 5

Install Casters:
(2) Casters (G) which have a built in locking brake and
(2) Casters (H) which do not have a built in locking brake
are supplied with this crib.
Note: Install the (2) Casters with Locking Brake on same
side of crib that Childcraft Logo on Stationary Side (K) is
on.
Install Casters (G and H) by sliding attached mounting
bracket over bottom end of each post on End Panels (I).
Attach each Caster (G and H) using (2) Allen Head
Bolts (D) and (2) Connector Nuts (E) as shown.
Align holes in Caster bracket with hole in post and
insert Allen Head Bolts (D) and Connector Nuts (E).
Once in the correct position, hold caster tightly
against bottom of post, thread Allen Head Bolts (D)
and Connector Nuts (E) together and tighten securely
using Allen Wrenches (A).
Note: Each Allen Head Bolt (D) has a friction
enhancing patch applied to the threads which will
cause some resistance during the tightening process.
See Figure 4.
Install Mattress:
Insert Mattress (M) into crib.
This completes the assembly.
Refer to remaining areas on the following pages prior to
use.
All manuals and user guides at all-guides.com STEP 5
STEP 6
5
D
H
E
Figure 4
Figure 5
Logo
E
D
G
AB20097A_G7
AB20097A_G1