Child Craft Bristol F99040 Guide D'assemblage page 4

Construct Front Assembly:
Attach the remaining Stationary Side (K) to the opposite
side of End Panels (I) using the same process described
in Step 1. Refer to Figure 1 diagram.
Filling Empty Holes In End Panels:
Additional Allen Head Bolts (C) and Connector Nuts
(E) are supplied to fill open holes in the End Panels to
prevent possible finger entrapment of a child. There are
2 empty holes (one in each post) in each of End Panels
(I) which can be used as a second possible height
adjustment of the Mattress Support Assembly.
Use 1 Allen Head Bolt (C) and 1 Connector Nut (E)
to fill each hole.
Insert Allen Head Bolt (C) from inside face and
thread into Connector Nut (E) which will be installed
from the outside face as shown.
Thread together and tighten using Allen Wrenches
(A).
Insert Allen Head Bolts (C) and Connector Nuts (E)
into all 4 empty holes.
See Figure 3.
All manuals and user guides at all-guides.com
STEP 3
STEP 4
4
E
Figure 3
C
AB20083A_G6