Pressure Wave PWH2500 Mode D'emploi page 11

STARTING
Prior to starting, refer to your engine
manual for proper starting procedure.
1. In a well ventilated outdoor
area add fresh, high quality,
unleaded gasoline with a pump
octane rating of 86 or higher. Do
not overfill. Wipe up spilled fuel
before starting the engine. Refer
to Engine Owners Manual for
correct procedure.
2. Check engine oil level. See
Engine Owners Manual for correct
procedure. NOTE: There will
be a slight amount of oil in the
engine from factory testing.
3. Verify the filter
screen is in
water inlet of
pump. NOTE:
Cone side
faces out.
4. Connect water
source to pump inlet. NOTE:
Water source must provide a
minimum of 5 gallons per minute at
20 PSI.
5. Connect high pressure hose to
pump outlet.
Water
Source
6. If applying a chemical or
cleaning solution, see How
To Apply Chemicals/Cleaning
Solvents instructions in this
section.
11- ENG
Filter Screen
A12496