Publicité
Les langues disponibles
Les langues disponibles
INVERTER REMOTE CONTROL
1.0 EWRC2 Inverter Remote Control Instructions
The EWRC2 can be used with the EW-1100, EW-2000, EW-3000 and EW-4000
inverters. It features a LED indicator showing inverter status, an on/o switch
and a 20' cable that simply plugs into the inverter.
1.1 Features
A: LED indicator
B: Push button
1.2 Indicator
Solid Green - Inverter "on"
No Colour - Inverter "o "
1.3 Functions
Short push (1 sec) - Inverter ON / OFF
2.0 Mounting the EWRC2 Inverter Remote Control
1.
Cut out the template at right and position it on the wall where the
remote is to be mounted.
2.
Mark the location of the four holes, and the square area to be cut out.
3.
Drill four holes, 1/8" (2.8mm) diameter and remove the cutout area.
4.
Feed the phone jack connector and wire through the cutout hole
in the panel and route the wire to the inverter phone jack
receptacle.
5.
Position the remote switch assembly upright and secure to the
panel using the four screws provided. Plug the phone jack
connector into the inverter. Press the button to turn the inverter on
and o .
2
A
STATUS | ÉTAT
B
ON | OFF
MARCHE | ARRÊT
INSTALLATION GUIDE
3.0 Mounting Template
35 mm
41 mm
51 mm
3
Publicité
