Clarion APX2121E Manuel D'utilisateur page 15

All manuals and user guides at all-guides.com
6. TROUBLESHOOTING
No Audio
•
Low or no remote turn-on voltage: check remote connections at the amplifier and
source unit.
•
Blown amplifier fuse: replace with a new fast-blow fuse (same rating).
•
Power wires not connected: check battery and ground wiring at the amplifier and
check the battery connections.
•
Speaker leads shorted: check speaker continuity to ground; it should not show a
common ground.
•
Speakers not connected or are blown: check speaker connections at the
amplifier; measure coil impedance.
Audio cycles on and off
•
Thermal protection circuits are shutting the amplifier off.
•
Check the location for adequate ventilation. Consult an authorized Clarion audio
dealer.
Distorted audio
•
Gain is not properly set or the speaker cones are damaged.
•
Review the instructions for setting the gain. Inspect each speaker cone for signs
of damage, such as a frozen cone, burning smell, etc.
Amplifier fuse keeps blowing
•
The wiring is connected incorrectly or there is a short circuit.
•
Review the installation precautions and diagram in this manual and check all
wiring connections.
Whining or ticking noise when engine on
•
The amplifier is picking up alternator or radiated noise.
•
Turn down input gain.
•
Move the audio cables away from the power wires.
•
Check the power and ground connections on the amplifier and install an in-line
noise filter on the source unit's power wire.
•
Check the alternator and/or voltage regulator. Test for a weak battery or add
water to the battery.
15