Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
XB, HV, HVA, HVAR, ADD, ADDR, DDS, DDP, SXB, SADD
10. Tighten all nuts, bolts and setscrews prior to fan start up (as some may have loosened during shipping).
11. On belt driven fans make sure that the belts are tensioned and aligned correctly.
12. Ensure that all protective guards and other safety devices are installed properly prior to fan start up.
WARNING
!
WARNING: GUARDING SHOULD BE USED IF FANS ARE MOUNTED LOWER THAN
Moving parts,
disconnect
power before
servicing.
1.
A qualified electrician in accordance with all local and National Electrical Codes should do all wiring.
2.
Lock off all power sources before any wiring is to be performed.
3.
Leave enough slack in the wiring to allow for motor movement when adjusting the belt tension.
4.
Excess wire must be restrained in order to prevent it from entering the shaft and propeller area.
5.
Disconnect switches are recommended and should be located near the fan in order to, swiftly cut off power in
case of an emergency and maintain complete control of the power source.
6.
Some motors may have to be removed in order to make the connections in the motor terminal box.
7.
Follow the wiring diagrams on the motor nameplate.
1.
Wall Fans
•
Extend the proper gauge wire to the fan motor.
•
Restrain excess wire from entering the shaft and propeller area
2.
Wall Fans with Cabinets
•
Remove guard from cabinet.
•
Drill a hole through the cabinet at a convenient location and pull the wires
through (never wire through the guard).
•
Restrain excess wire from entering the shaft and propeller area
Pre Start Inspection
• Lock out all power sources
• Inspect all fasteners and set screws and tighten as required
• Inspect belt alignment and tension
• Confirm power source voltage and motor voltage are the same and that the motor is wired correctly
• Rotate the fan blade to ensure that neither the fan blade nor the belts come into contact with the housing
• Inspect the fan and the ductwork to ensure they are free of debris
• Check to ensure that all guards and accessories are securely mounted
• Check to be sure the propeller rotation is correct
M0112_NOV 2020
Canarm Ltd. - Corporate Head Office
Tel: (613) 342-5424
INSTALLATION CONTINUED
SEVEN FEET (2 METRES) OFF FLOOR OR GROUND LEVEL.
STANDARD WIRING INSTRUCTIONS
OPERATION
www.CANARM.COM
2157 Parkedale Avenue, PO Box 367
Fax: (613) 342-8437
Brockville, Ontario Canada K6V 5V6
hvacsales@canarm.ca
Page 2 of 8
www.canarm.com
Publicité
Table des Matières
