Télécharger Imprimer la page

Brunton SOLO 15 Mode D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

the unit is being charged the green LED's will remain illuminated until the battery pack
is fully charged.
SPECIFICATIONS
IX. Battery Supply
Internal Battery Type
Internal nominal battery Voltage
Internal battery capacity
Expected cycle life to 70% of original capacity
Current Rating
X. Charge Input Jack
• The inlet will accept any 2.5 mm by 5.5 mm barrel jack.
• Charge input is rated for 11V DC to 16V DC.
Wall Transformer
Input Voltage
Output Voltage
Output Current
Power
XI. FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digi-
tal device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed
and used in accordance with the instructions, it may cause harmful interference to
radio communications. However there is no guarantee that interference will not occur
5
Lithium Iron Phosphate (LiFePO
12.8 Volts
5.6 Amp Hours for Solo 7.5 & 12.8 Amp Hours for
Solo 15
1000 cycles
3 Amps nominal, 5 Amps peak
110 Volt AC
16 Volt
3.36 Amps
54 Watts
)
4

Publicité

loading

Ce manuel est également adapté pour:

Solo 7.5