Télécharger Imprimer la page

Cleaning The Shield; Sparkplug; Air Filter; Storing And Maintenance - Texas XTA 48 TR/W Manuel De L'utilisateur

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38

Cleaning the shield

It is recommended to clean the deck with a garden hose after each use See Fig 9
1. Attach the garden hose on the shield nozzle located on the left side attach the other
end of the garden hose to the water supply.
2. Ensure that the garden hose is firmly seated to the nozzle if so turn on the water.
3. Start the mower (see start and stop) Engage the upper rally bar in order to clean.
The deck

Sparkplug

1. Remove the spark plug cap.
2. Brush off dirt from the top of spark plug.
3. Use a spark plug wrench to loosen the spark plug.
4. Check that the isolation is intact.
5. Clean the spark plug with a steel brush.
6. Measure the electrode distance. Be careful not to damage the electrode.
7. The distance should be: 0,7 - 0,8 mm
8. If the spark plug is undamaged refit. Otherwise replace using Denso type
W20EPR-U.
9. Mount the spark plug cap

Air filter

The fir filter must be checked and cleaned regularly. If the filter has not been cleaned for
some time, the power of the engine is reduced, and the engine may be damaged.
1. Clean around the air filter before it is removed.
2. Press down the two flaps and carefully pull of the cover.
3. Carefully remove the paper filter and check it. Brush it with a soft brush. If it is very
dirty, it must be changed. Take care that no dirt gets into the intake of the engine.
4. Wash the black foam element on the right side in warm soapy water.
5. Press the water out of the foam element and let it dry. Put a few drops of SAE-30 oil
on the filter to moisten it lightly with oil. Carefully squeeze out any surplus oil.
Remount the element.
6. Check that all parts are fitted correctly and the cover closed as shown in the picture.

Storing and maintenance

Maintain your lawnmower on a regular basic:
Check all bolts, screws and deck. Always make sure the knife is sharp. It is
recommended that the knife is changed every 2 years. It is a good idea to let your local
service shop check your lawnmower once a year.
Storing: Keep the lawnmower in dry clean room. Clean the machine every time it has
been used. Grass and dirt must be removed from the inside of the cutting deck. Tilt the
front of the lawnmower for cleaning, maximum 45 degrees. If you tilt it to the side, the
carburettor and air filter must always turn up. If it does not turn up, the oil may run out
All manuals and user guides at all-guides.com
19

Publicité

loading