Reactivating The Airbag System - Helite E-GP AIR Manuel D'utilisation

F. PRECAUTIONS BEFORE USING THE AIRBAG SYSTEM
If one of these conditions is not validated, you may not be protected
properly.
The vest is adjusted correctly to your size.
The e-cartridge must be new and properly connected to the system.
The velcro of the e-GP Air is correctly closed.
The vest is sufficiently charged (green LED on).
The green LED is on and flashes.

6. Reactivating the airbag system

After activation, you can reuse the vest. Here are the steps to follow before reusing it
optimally.
See schema 6 on the schematic manual
1. Take off the vest.
2. Open the velcros on the front.
3. Remove the empty e-cartridge.
y a) Disconnect the e-cartridge.
y b) Unscrew the e-cartridge.
y c) Remove the e-cartridge with the cable.
4. Remove air from the vest with both hands.
5. Install a new e-cartridge.
y a) Slide the e-cartridge cable in the cylinder.
y b) Screw the e-cartridge.
y c) Connect the e-cartridge (cartridge symbol).
CAUTION Do not damage the cable
while screwing the e-cartridge e.g.
by bending it). Only connect the
e-cartridge once it is entirely screwed
(see example on the scheme below).
6. Close the velcros.
7. The vest can be reused.
CAUTION The e-cartridge must be
screwed entirely. Do not apply too
much pressure when screwing in the
cartridge.
User Guide
!
For the steps 2 to
5 the vest must
always be
switched off.
21