Engine Sensing - Firstech DroneMobile DR-2000 Guide D'installation

TM

Engine Sensing

Tach Sensing
The default engine sensing mode is tach through a bypass module. There are new features that adjust
tach reading methods on option 1-06.
tach sensing.
Foot brake must be connected if not supported by
STEP 1:
the bypass module. See Option 2-05 for details.
Start the vehicle with the key. Allow time for the
STEP 2:
engine to idle down.
Learn tach. While the vehicle is at idle, hold the
STEP 3:
foot brake and activate the remote start function on the
remote control for 2.5 seconds. The parking lights will flash
once to indicate a good tach signal. The parking lights will
flash twice to indicate the tach did not learn. Two seconds
following the two flashes, the number of parking light flashes
will indicate the cause of the error:
– (Automatic Transmission Vehicles Only)
Tachless Mode
Tachless sensing is an alternative engine sensing mode. It does not require a connection to the vehicle
other than the main ignition harness.
Change Option 1-06 to setting 2 – No tach sensing.
STEP 1:
Process complete – there is no further programming required other than adjusting crank time
STEP 2:
when necessary (see below).
Timed Crank Setting – Automatic Transmission Only
Option 1-06 setting 3 provides a timed 1.5 second crank for the remote start sequence. This option
just cranks the vehicle for 1.5 seconds and assumes remote start has completed. This option can be
used for GM and other vehicles with built in anti-grind systems.
All manuals and user guides at all-guides.com
DR-2000 Install Guide
IMPORTANT:
The remotes must be coded prior to setting up
Number
of Parking
Light Flashes
1
2
3
Programming
Tach Error
Option 2-10 is not in
default setting 1
Key is in the off position
Bad tach signal. Find a
different wire.
Copyright 2011 Firstech, LLC. | 12