Display
Status Meaning
is lit red The charger is not properly
flashes
red
is lit
yellow
is lit
green
▸
Plug the charger plug in the connector [10] at the
side of the device.
▸
Check if the voltage applied to the AC outlet volt-
age matches the input voltage of the charger.
▸
Plug the charger plug in a wall socket.
During charging, the yellow LED lights
up. Once the charging process is
completed, the green LED lights up. A
complete charging process can last up to
24 hours.
▸
After charging, disconnect the charger from the
alternating current source.
▸
Disconnect all connections between the charger
and the Power Start.
All manuals and user guides at all-guides.com
connected to the device, the
charging will not start.
The charging process can not
be completed normally and
will be aborted.
▸
To reset the device after
an aborted charging, dis-
connect the charger from
the power outlet for a few
seconds.
The device is being charged.
The device is fully charged
and the charger is in the trickle
mode, this means, the full
charge of the battery is main-
tained without damaging it.
Check charging state
Attention !
Only use the device only in a fully charged state
¾
▸
Ensure that the operating switch [3] is set to "0"
and that the device is not connected to the vehicle
battery.
▸
Press the charging state button [7].
The charging state of the device is indicated on
3
the display [6] in percent.
Upon switching on the operating switch
[3], the voltage of the internal battery is
shown in volt.
Vehicle battery voltage
If the Power Start is connected to a vehicle and
3
the operating switch [3] is set to "0", then the ve-
hicle battery voltage is shown on the display [6].
If the Power Start is connected to a vehicle and
3
switched on, then the average voltage between
the vehicle battery and the internal battery of the
Power Start is shown on the display [6].
The battery charge state is displayed
most accurately when the Power Start
was disconnected from any external
devices and charging sources for several
hours.
17