Sony XAV-A1 Manuel page 13

Notes
• Do not press the front panel buttons of
the unit during installation and do not
apply strong force.
• Do not place any objects on top of the
unit.
• If a salient of the genuine bracket
touches the unit due to its figure, and
makes attachment hard, process the
bracket by scraping the salient off.
Toyota cars (illustration shows an example for a Toyota car)
Align the brackets of the factory-installed car stereo with the
mounting holes marked "T" on the side of the main unit, and use
the supplied screws to fasten the brackets. For Toyota cars, the
supplied screws 6 should be used.
Screws of factory-
installed car stereo
bracket
Nissan cars
Align the brackets of the factory-installed car stereo with the
mounting holes marked "N" on the side of the main unit, and use
the supplied pan-head screws 6 to fasten the brackets.
Screws of factory-
installed car stereo
bracket
* Be sure to use only the supplied pan-head screws 6 for
installation. If any other screws are used, make sure they
conform to the requirements shown below.
Using longer screws can cause internal damage to the unit.
6 mm
Damage can also occur if the screws are used directly on the
unit without the brackets of the factory-installed car stereo.
6
XAV-A1
XAV-C1
6
XAV-A1
XAV-C1
5 mm
Bracket of
factory-installed
car stereo
Bracket of
factory-installed
car stereo
13