Troubleshooting - NewAir NIM045SS00 Manuel De L'utilisateur

TROUBLESHOOTING

Problem
< > is on
< > is on
The water reservoir
has water, but<
> is on
<E1> is on
<E2> is on
No water in the
water Separator
pipe
Ice cube are too
thick and can't Drop
down
Ice cube thin
Unit work but no ice
cube
www.newair.com
Possible Causes
Lack of water
Too much ice in the ice
basket
The inlet solenoid valve
breakdown
Ambient temp sensor
breakdown
Water temp sensor
breakdown
The holes are blocked
Water filter block
Ice making cycle too long
Ambient temp too high
Water temp too high
Ice making time too short
Ambient temp is high or the
Water temp is high
Refrigerant system
leakage
Refrigerant system block
Solution
Turn off the unit and add
water to <FULL>level, then
re-start the unit.
Remove the ice cubes in the
basket
Need the technical service
person to maintain
The unit can still work,
change to a new sensor
The unit can still work,
change to a new sensor
Use slim wire to prick each
hole, till
The water can flow out
easily.
Clean the water filter
Press <->to reduce the ice
making
time.
Move the unit to cool place
no more than 77 F (25 C).
The water temp should be
Press<+>to increase the ice
making Time.
Move the unit to
somewhere ambient Temp
lower than 86 F (30 C), fill
cool water.
Need the technical service
person to
maintain
Need the technical service
person to
maintain
EN
18