Automatic Self-Cleaning Program - NewAir NIM045SS00 Manuel De L'utilisateur

3. When cleaning, if you find that ice cubes are left on the evaporator and
cannot be taken out easily, you can turn on the unit to let the unit enter
the ice making process, then press
to let the unit start ice harvest process to melt the ice cube. It will help you
remove the hard ice cube.
How to drain out the water from the internal tank and water reservoir
completely
To drain the water reservoir, use the drain port by the water valve. If you want
to drain away all the water, please plug on the unit, but don't start the unit,
then remove the water drainage cap at the bottom. Wait some minutes, then
all of the water will flow out.

AUTOMATIC SELF-CLEANING PROGRAM

Start the self-cleaning program: Plug on the unit, press
for more than 5 seconds, to enter the self-Cleaning program need 20minutes.the
symbol rotate on display screens, time count down area display 20M.
Cancel the self-cleaning program: It takes about 20 minutes to complete one self-
cleaning cycle. When the program is over, the system will be off automatically. You
can press the button on control panel to
force.
Warning
A. Make sure the water tank, water filter and the water separator pipe are not
blocked, clean them.
B. The water temp will affect the ice making capacity. The lower temp, the more ice
cubes will be produced.
C. The cooler the ambient temp, the more ice cubes are produced.
D. Always use good quality water to make sure the pump work well. Bad quality water
will cause pump to make noise, but doesn't affect the unit from working.
E.
The compressor will restart 3 mins later if you turn off the unit.
www.newair.com
button for more than 5 seconds
button on control panel
cancel the self-cleaning program by
EN
17