Specifications; Legal Notices - Dynex DX-EBDTC Guide De L'utilisateur

24
3 From the Advanced tab, uncheck Use Windows to configure my wireless
network. After the box is unchecked, click OK to close the window.
You are now using the WNU to configure the card.
The card is not detected by operating system
• The card is not recognized by your desktop computer.
• The New Hardware Wizard does not appear when booting up the computer.
• You receive Microsoft Error Code: 10
• You receive Microsoft Error Code: 0
To correct the problem try moving the card to another PCI slot. See "Installing the wireless
card" on page 9.

Specifications

Host Interface
Power Consumption
Operating Temperature
Storage Temperature
Humidity
Typical Operating Range

Legal notices

FCC Statement
DECLARATION OF CONFORMITY WITH FCC RULES FOR
ELECTROMAGNETIC COMPATIBILITY
We, the Dynex Corporation, of 7601 Penn Avenue South, Richfield, Minnesota, U.S.A., declare
under our sole responsibility that the product, DX-EBDTC, to which this declaration relates,
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: Exposure to Radio Frequency Radiation.
The radiated output power of this device is far below the FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact
during normal operation is minimized. When connecting an external antenna to the device,
the antenna shall be placed in such a manner to minimize the potential for human contact
during normal operation. In order to avoid the possibility of exceeding the FCC radio
frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8
inches) during normal operation.
32-bit PCI
Tx/Rx peak 510/250mA @ 3.3VDC (max.)
32 to 140 degrees F (0 to 60 degrees C)
-4 to 176 degrees F (-20 to 80 degrees C)
Max. 90% (non-condensing)
100 to 200 ft. (30 to 60 m) indoors
Specifications