Ice Cube Tray - Simplicity SYFF123C1WL Guide D'utilisation Et Soins De Propriètaire

Installation Instructions
FEATURES
8
9
ICE CUBE TRAY
The Ice Cube Tray is flexible. Twist tray to remove the ice cubes. If the ice cube
tray is frozen solid, run a little water over the tray. Never use a knife or other metal
instruments to remove the ice cube tray from freezer compartment, as this may
damage the evaporator.
CHANGING LED LIGHT (please follow the steps below)
We recommend that you start by unplugging your refrigerator unit.
1. Take off the light cover by flicking the bottom tab up (the bottom tab is located at the bottom middle of the light cover).
2. Take out the LED display by pulling it down and unhooking it from the port, it is best to use your thumb on the front of
the LED and you fingers at the back near the port.
3. Put in the new LED by inserting it into the port.
4. Once the LED is secured, put the cover back on by inserting the two top tabs in to their slots and pushing the bottom
tab back into place, you should hear a quiet click.
Once you have secured the light cover back on, you can plug your refrigerator back in.
Take off the light cover by
flicking up bottom tab
1
Bottom tab
Unhook the LED display
using your thumb and fingers
You will see the LED display
2
Hook the new LED display to the
port
3
1) FREEZER DOOR BIN
2) REFRIGERATOR DOOR BIN
3) FREEZER SHELF
4) FREEZER TEMPERATURE CONTROL PANEL
5) REFRIGERATOR TEMPERATURE CONTROL
6) INTERIOR LIGHT
7) REFRIGERATOR SHELF
8) CRISPER
9) LEVELING LEGS
Pull the LED display down
Put the cover
Top tabs
back on
4
5