Auto Dry Cycles - Kenmore 6012 Guide D'utilisation Et D'entretien

3.
Select the desired cycle
Appearance may vary.
Select the desired cycle for your load. See the "Cycle Guide"
for more information about each cycle.

Auto Dry cycles

You can select a different dry level, depending on your load,
by turning the knob to More, Normal, or Less.
Selecting More, Normal, or Less automatically adjusts the
dryness level at which the dryer will shut off. Once a dry level
is set, it cannot be changed without stopping the cycle.
Auto Dry cycles give the best drying in the shortest time. Drying
time varies based on fabric type, load size, and dryness setting.
NOTE: More Dry removes more load moisture. Normal Dry is
used for a starting point for Auto Dry cycles. Choose normal
to save energy. Less Dry removes less moisture and is used for
loads you may want to put on a hanger to complete drying.
4.
Set temperature (on some models)
Turn the DRY TEMP knob to change the drying temperature
setting. See "Setting the Drying Temperature."
8
5.
Select Cycle Signal, if desired
(on some models)
Turn the CYCLE SIGNAL knob to select the desired setting
(On or Off). The Cycle Signal produces an audible sound when
the drying cycle is finished. Promptly removing clothes at the
end of the cycle reduces wrinkling.
NOTE: During the Wrinkle Guard™ function and if the Cycle
Signal is on, the tone will sound every 5 minutes until the clothes
are removed or the Wrinkle Guard™ function ends.
6.
Press and hold PUSH TO START
to begin cycle
Appearance may vary.
Press and hold the PUSH TO START button to begin the cycle.
Promptly remove garments after cycle has completed to
reduce wrinkling. The Wrinkle Guard™ function at the end of
the cycle avoids wrinkling when you are unable to remove a load
from the dryer as soon as it stops.