Saba HD600BOX-60 Mode D'emploi page 18

Mark points on the lines making sure their perfect
horizontal alignment
• Mark 3 points (1) on A line, at 80 mm at both sides, including
the central mark on the reference line (you may better use the
bracket 20 to mark easily the points)
• Mark 2 points (2) on B line, at 60 mm at both sides of the
vertical reference line�
• Mark 2 point (3) on C line, at 60 mm at both sides of the
vertical line�
Fix the brackets:
• Drill holes at the marked points with a Φ10 mm drill bit�
GB
By measure of precaution, it is recommended to drill the holes at
points (2) on B line only once the lower chimney with bracket 21
is assembled on the hood unit� (refer to Fig�2)�
It allows to verify if the holes of the bracket are precisely on-line
B otherwise mark new points directly from the bracket after
assembly�
• Insert the Wall Plugs 11 into the holes�
• Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) at the
horizontal line A�
• Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) at
the horizontal line C�
30
All manuals and user guides at all-guides.com
Lower decorative chimney (Fig. 1)
• Connect the exhaust pipe on the hood body
• Assemble lower chimney on hood body with 2 screws 12,
• Fix bracket 21 on the chimney with 2 screws 12�
Hook the hood unit
• Hook the hood unit to the bracket 20 and level the hood
properly�
• Check if the holes of bracket 21 are precisely at points (2) on
line B otherwise mark new points directly from the bracket�
• Remove the hood, drill holes and insert wall plugs�
• Reinstall the hood and fix firmly with 2 screws 5x50 on bracket
21�
Figure 1
Figure 2
GB
31