Marc Jacobs 2405 Instructions page 3

AUTOMATIC 82S5
1. To start time-keeping, rotate the crown clockwise 15-20 times in
position 1.
2. Pull crown out to position 2 and rotate clockwise to set time.
3. Return crown to position 1.
NOTE: A timepiece with an automatic winding movement obtains the
power to wind itself by the movement of your wrist, there is no battery.
Therefore, not wearing the timepiece for several consecutive days could
exhaust the power reserve. If your watch stops, it is recommended that
you manually wind the movement by rotating the crown clockwise to
achieve the necessary power reserve.
It is important your timepiece is adjusted to match the size of your wrist.
A loose fit may result in a loss in capacity of the timepiece to wind itself.
When fully wound, your timepiece has a power reserve of approximately
40 hours.
4
CHRONOGRAPH STOPWATCH VD53B
MINUTE HAND
SECOND HAND
TIME AND DATE SETTING
1. Before setting the time, make sure the chronograph is stopped
and set to zero (12:00) position.
2. Pull crown out to position 2.
3. Turn crown clockwise until the previous day's date is displayed.
4. Pull crown out to position 3 when the second hand is at the
12:00 position.
5. Turn crown to set time.
NOTE: 24-hour hand moves correspondingly with the hour and
minute hands. When setting the time be sure to check that the
24-hour hand is set properly.
6. Return crown to position 1.
NOTE: When the crown is in position 2, do not press the pushers,
otherwise the chronograph hands will move.
CHRONOGRAPH
1. Press A to start/stop the chronograph.
2. Press B to reset to zero.
24-HOUR HAND
5