Chicago Pneumatic CP3109-13AC Mode D'emploi page 4

2050541123
Issue no: 02
Series: C
Original instructions.
© Copyright 2010, Chicago Pneumatic
Tool Co. LLC
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
INSTRUCTIONS
This product is designed for removing
material using abrasives. No other
use permitted. For professional use
only. Before servicing the power tool,
the supply of compressed air must be
disconnected or shut off.
When disposing of components,
lubricants, etc ... ensure that the
relevant safety procedures are carried
out.
The tool is designed for a working
pressure of 6.3 bar (90 psig). The
compressed air must be clean. The
installation of a filter is recommended.
For maximum efficiency and
performance, comply with the
specification of the air hose (antistatic
hose). (Refer to figure no.1 for
compressed air connection).
A: Ømini = 10mm (3/8")
B: 7 m max.
A
To obtain maximum efficiency from the
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme
are recommended at least every 500
hours, the intervals between the various
inspections depending on the amount of
exertion on the power tool.
For dust extraction, please contact your
local sales.
4 / 28
Declaration of noise and vibration emission
(See page 28).
All values are current as of the date of this
publication. For the latest information please visit
www.cp.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well upon the exposure
time and the physical condition of the user.
We, Chicago Pneumatic, cannot be held liable
for the consequences of using the declared
values, instead of values reflecting the actual
exposure, in an individual risk assessment in
a work place situation over which we have no
control.
This tool may cause hand-arm vibration
B
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration
can be found at http://www.humanvibration.com/
EU/VIBGUIDE.htm
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so
that management procedures can be modified to
help prevent future impairment.
Check the free speed of the tool
at regular intervals and after each
operation or maintenance task. Remove
the abrasive to check the speed. The
maximum allowed speed shown on
the tool must not be exceeded and the
vibration level must not be excessive.
This tool is fitted with blades which can
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil
may reduce the life of blades.
07/2019